Eden260V User Guide
Resuming Production After Printing has Stopped
If the printing process is interrupted, Job Manager stops sending slices to the
printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to Standby or Idle mode, you need to resume printing
from the Job Manager screen of Objet Studio.
After printing stops, the printer goes into Standby mode, when heating of the
print heads is reduced. About 10 hours later, the printer goes into Idle mode,
when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in offline mode, switch it to online mode by clicking the red
2. If you don't know why printing has stopped, make sure that the connection
3. In the Job Manager screen of Objet Studio, click the Resume icon
4. In the Continue from Slice dialog box that appears, confirm the slice number,
5. If, for any reason, the correct number does not appear in the dialog box, enter
DOC-32020 Rev. F
button at the bottom of the printer interface (see the figure on page 6-4).
The button changes from red to green.
between the printer and the server computer is active.
after checking the printer interface.
Figure 6-6 Printer interface after interrupted printing
Figure 6-7 Continue from Slice confirmation in Objet Studio (Job
Manager screen)
the number and click OK.
6 Operating and Maintaining the Printer
.
6-10