Resuming Production After Printing Has Stopped - Stratasys J850 User Manual

Stratasys J850/J835 User Guide

Resuming Production After Printing has Stopped

If the printing process is interrupted, the print manager stops sending slices to
the printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to Standby or Idle mode, you need to resume printing
from the print manager in GrabCAD Print.
After printing stops, the printer goes into Standby mode, when heating of
the print heads is reduced. About 10 hours later, the printer goes into Idle
mode, when heating of the print heads is stopped.
To continue printing :
1. If the printer is in offline mode, switch it to online mode by clicking the red
2. If you don't know why printing has stopped, make sure that the connection
3. Open the Schedule screen of GrabCAD Print.
Figure 4-30 Opening the Schedule screen
4. Locate the stopped job.
Figure 4-31 Stopped job in the Schedule screen
5. Click on the job to display the Job Status details, and click the Resume icon
DOC-18001 Rev. N
button at the bottom of the printer interface (see the figure on page 4-4).
The button changes from red to green.
between the printer and the server computer is active.
.
OR—
Right-click on the job to display the pop-up menu, and select Resume job.
4 Operating and Maintaining the Printer
4-21