Table of Contents
Advertisement
Pattern limit: You can restrict the range of the transition as desired. However,
Size: This can only be used when one of the following pattern numbers is
Crop: You can crop the image. It is also possible in 16:9 mode to crop both
Relation Between DME Wipes and Other Effects
The relations between DME wipes and other effects are as follows.
Relation to ordinary wipes
• DME wipes do not use the wipe generator built into the switcher. Therefore,
during the execution of a DME wipe, you can still use a pattern produced by
the wipe generator as the source for a pattern key or mask.
• A DME wipe pattern cannot be used as the source for a pattern key or mask.
76
DME Wipes
• 2851 to 2854, 2861 to 2864
When these pattern numbers are selected, you can set the pattern position
for each channel setting when the first transition completes.
this is not available for a DME wipe in the independent key transition
control block.
For more details, see "Pattern Limit" (page 315).
selected.
• 1201 to 1208, 1221 to 1224, 1251
• 2651, 2652, 2851 to 2854, 2861 to 2864
You can set the size of the image.
sides, to convert the image to a 4:3 aspect ratio. For the execution of a
DME wipe crop transition, you can select from the following three
possibilities.
• Cut
• Last 5%
• Linear
When [Last 5%] is selected, you can set the [Release Transition] as
follows.
• Last 30%
• Last 5%
• Off
Note
When pattern numbers 1701 and 1702 are selected, crop cannot be used.
Advertisement
Table of Contents
