Setting Wipe Modifiers - Sony MVS-8000X SystemMVS-7000X System User Manual

2
In the same way as for the main pattern, select the sub
pattern.
The patterns that can be selected for the sub pattern
depend on the pattern selected for the main pattern (see
the following table).
Yes: Combination possible No: Combination not possible
Main Sub pattern
pattern
Standard Enhanced Rotary
Standard Yes
Yes
Enhanced Yes
Yes
Rotary No No
Mosaic Yes Yes
Random/
Yes Yes
diamond
dust
3
Select HF2 'Pattern Mix.'
The Pattern Mix menu appears.
4
In the <Pattern Mix> group, select the type of pattern
mix (see page 164).
Mix: mix
+Nam: positive Nam
–Nam: negative Nam
Morphing: morphing
5
Depending on the selection in step 4, set the following
parameters.
When mix, positive Nam, or negative Nam is
selected
Knob Parameter Adjustment
1 Mix Ratio
When morphing (see page 165) is selected
Knob Parameter Adjustment
2 Start
3 End
6
In the <Main/Sub Link> group, make the main/sub
modifier link function settings (see page 165).
166
Basic Procedure for Wipe Settings
Mosaic Random/
diamond
dust
No Yes Yes
No Yes Yes
No No No
No No Yes
No Yes No
Setting values
Proportion of 0.00 to 100.00
sub pattern to
the main pattern
Setting values
–50.00 to
Point in
+150.00
transition at
which main
pattern is at
100%
–50.00 to
Point in
transition at +150.00
which sub
pattern is at
100%
Full: fully linked mode
Semi: semi-linked mode
Applying the effect of a diamond dust wipe
to the selected pattern (Dust mix)
1
In the Pattern Mix menu, press [Dust Mix], turning it
on.
2
Set the following parameters as required.
Knob Parameter Adjustment
1 Mix Ratio Proportion of
diamond dust
pattern in mix
2 H Size Particle width
3 V Size Particle height
4 Flash Rate Rate of
generation of
particles
You can also apply the dust mix function to the pattern
generated by a pattern mix.
Notes
When a random/diamond dust wipe (pattern numbers
270-274) is selected, the dust mix function is not
available.

Setting Wipe Modifiers

You can apply various modifiers to the wipe pattern:
setting the wipe direction, pattern position, and so on.
Note that the available modifiers may depend on the
pattern you are using (see page 174).
Main pattern and sub pattern modifiers
You can make independent settings of the modifiers for the
main pattern and sub pattern.
• To set the modifiers for the main pattern, in the M/E-1
>Wipe menu, select HF5 'Main Modify,' and make the
settings in the Main Modify menu.
• To set the modifiers for the sub pattern, select HF6 'Sub
Modify,' and make the settings in the Sub Modify menu.
Operations in the Main Modify menu and Sub Modify
menu are the same.
Independently set modifiers for the main pattern
and sub pattern
• Positioner
• Rotation
• Aspect ratio
• Pattern replication (MULTI)
• Pairing
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00