Honda CB 600F Hornet 2007 Shop Manual page 163

Table of Contents

2. Install the rubber cap and seat it onto the fuel

joint flange as shown.

Align the quick connect fitting with the fuel joint

and align the new retainer locking pawls with the

connector grooves.

Then press the quick connect fitting onto the fuel

joint until both retainer pawls lock with a

If it is hard to connect, put a small amount of

engine oil on the joint end.

3. Make sure the connection is secure and that the

pawls are firmly locked into place; check visually

and by pulling the connector.

4. Mak.e sure the rubber cap is in place (between

the flange and retainer tab).

5. Connect the fuel pump 2P (Black) connector and

clamp the wire.

6. Connect the battery negative (-) cable to the bat

Do not start the

7. Turn the ignition switch ON and engine stop

The fuel pump will run for about 2 seconds, and

fuel pressure will rise.

Repeat 2 or 3 times, and check that there is no

leakage in the fuel supply system.

Remove the support tool, then install and tighten

the fuel tank front mounting bolts (page 3-6).

FUEL SYSTEM (PGM-FI)

LOCKING PAWLS

2P (Black) CONNECTOR

Show Quick Links

Chapters

Table of Contents