Honda CB 600F Hornet 2007 Shop Manual page 79

MAINTENANCE
Apply engine oil to the timing hole cap 0-ring.
Check that the O­
Apply grease to the timing hole cap threads.
ring 1s m good
condmon. replace If
Install and tighten the timing hole cap to the speci­
necessa,y
fied torque.
TORQUE: 18 N·m (1.8 kgf•m. 13 lbf-ft)
Remove the cam chain tensioner stopper tool.
Install a new sealing washer and cam chain
tensioner lifter sealing bolt.
Tighten the bolt securely.
Install the cylinder head cover (page 8-31 ).
ENGINE OIL/OIL FILTER
OIL LEVEL INSPECTION
Place the motorcycle on the level ground with its
sidestand.
Start the engine and let it idle for 3
Stop the engine and wait 2- 3 minutes.
Hold the motorcycle in an upright position.
Check the oil level through the inspection window.
If the level is below the lower level line, fill the
crankcase with the recommended oil up to the
upper level line as following procedures.
Remove the oil filler cap.
3-14
BOLT
V
"-­
g
�
SEALING WASHER
- 5 minutes.
CAM CHAIN TENSIONER LIFTER
I
\
,p_