Make sure the needle rollers in the bearing are in
position.
Apply grease to new dust seal lips.
Install the dust seals with the flat surface facing out
until they are flush with the lower pivot surface.
Install the pivot collar.
INSTALLATION
Install the shock absorber into the frame.
Install the upper mounting bolt from the left side
and install the nut.
Tighten the nut to the specified torque.
TORQUE: 42 N·m (4.3 kgf•m, 21 lbf·ft)
Install the lower mounting bolt from the left side
and install the nut.
Tighten the nut to the specified torque.
TORQUE: 42 N•m (4.3 kgf•m. 21 lbf•ft)
Insert the drive chain case slit into the boss of
swingarm.
REAR WHEEL/SUSPENSION
......
¢!�
'°�
DUST SEALS
COLLAR
14-17