Honda CB 600F Hornet 2007 Shop Manual page 407

If the driven sprocket was removed, tighten the nuts
to the specified torque.
TORQUE: 108 N•m (11.0 kgf•m, 80 lbf•ftl
Apply grease to the dust seal lips and install the
dust seal until it is nush with the driven flange.
Install the brake disc with its rotating direction mark
facing out.
Install and tighten new bolts to the specified torque.
TORQUE: 42 N•m 14.3 kgf•m, 31 lbf·ftl
Apply grease to the dust seal lips and install the
Do not get grease
dust seal until it is flush with the wheel hub.
on the brake disc or
stopping power will
be redvced.
Install the speed sensor pulser ring onto the right
CB600FA only:
wheel hub.
Install the new torx bolts and tighten them to the
specified torque.
TORQUE: 7.0 N-m (0.7 kgf•m, 5.2 lbf-ft)
INSTALLATION
Install the side collars.
REAR WHEEUSUSPENSION
DI MARK •
����--:"""r--;.--:-,ilii.iiiiiiiii.:'!111•-
S
8
LSER RING
•
1 1
,,
l
I
,
- -
J'.
-
RX BOLTS
14-13