Honda CB 600F Hornet 2007 Shop Manual page 444

Apply silicone grease to the brake lever pivot bolt
sliding surface.
Install the brake lever and pivot bolt, and tighten it.
TORQUE: 1.0 N•m (0.1 kgf•m, 0.7 lbf•ft)
Install the nut and tighten it while holding the pivot
bolt.
TORQUE: 5.9 N·m (0.6 kgf•m, 4.4 lbf•ft)
Install the master cylinder, holder and bolts.
Install the master
Align the edge of the master cylinder with the
cylinder holder with
punch mark on the handlebar, and tighten the upper
its ·up- mark facing
bolt first, then the lower bolt.
up.
TORQUE: 12 N·m (1.2 kgf•m, 9 lbf•ft)
Connect the brake hose to the master cylinder with
the oil bolt and new sealing washers.
Tighten the oil bolt while holding the hose eyelet
against the stopper.
TORQUE: 34 N·m (3.5 kgf•m, 25 lbf•ft)
Connect the brake light switch wire connectors.
Fill and bleed the hydraulic system:
- CBF600FA (page 15-7)
- CBF600F (page 15-13)
REAR MASTER CYLINDER/BRAKE
PEDAL
REMOVAL
Drain the fluid from the brake hydraulic system """'"""""
(page 15-7).
Remove the bolt and rear brake fluid reservoir.
Disconnect the rear brake light switch 2P (black)
connector.
HYDRAULIC BRAKE
� PIVOT BOLT
.
g
�
SEALING WASHERS
OIL BOLT
15-25