BRAKE/TAIL LIGHT
LICENSE LIGHT
L
REAR TURN SIGNAL LIGHT
Remove the rear cowl (page 2-6).
Disconnect the rear turn signal light 2P connector.
Remove the mounting nut, setting plate and turn
signal unit.
Installation is in the reverse order of removal.
Tighten the mounting nut to the specified torque.
TORQUE: 5.0 N·m (0.5 kgf•m, 3.7 lbf·ft)
INSPECTION
Turn the ignition switch ON, and check the tail light
operation.
Check that all LED in the brake/tail light unit illumi
nate with the front brake lever and/or rear brake
pedal applied.
If any LED does not turn on, replace the brake/tail
light assembly (page 2-6).
•
For brake/tail light removal/installation (page 2-
6).
BULB REPLACEMENT
Remove the screws and license light case.
LIGHTS/METER/SWITCHES
20-9