Gearshift Linkage - Honda CB 600F Hornet 2007 Shop Manual

CLUTCH/STARTER CLUTCH/GEARSHIFT LINKAGE
Apply engine oil to the starter clutch mounting bolt
threads and seating surface.
Install the washer and starter clutch mounting bolt.
Temporarily install the following:
- oil pump drive sprocket guide
- oil pump drive sprocket
clutch outer
- clutch outer guide
- clutch outer needle bearing
Be C1Jreful nor to Attach the gear holder between the primary drive
drop the gear gear and driven gear.
holder into rhe
TOOL:
crankcase.
Gear holder, M2.5
Tighten the starter clutch mounting bolt to the spec­
ified torque.
TORQUE: 83 N•m (8.5 kgf•m, 61 lbf-ft)
Remove the temporarily installed parts.
Apply molybdenum oil solution to the starter reduc­
tion gear sliding surface.
Install the starter reduction gear into the crankcase.
Install the clutch (page 9-13).

GEARSHIFT LINKAGE

REMOVAL
Remove the following:
- right crankcase cover (page 9-5)
- clutch (page 9-6)
Remove the pinch bolt and disconnect the gearshift
arm from the gearshift spindle.
9-22
07724-0010100