FUEL SYSTEM (PGM-FI)
INSTALLATION
Install each insulator onto the throttle body while
aligning its groove with the lug on the throttle body.
Align the hole on each insulator band with the boss
on the insulator.
Confirm the direction of the insulator band screws
as shown.
Tighten the throttle body side insulator band screws
so tllat the
mm
(0.28
Connect the throttle cables and tighten the lock
nuts.
Install the throttle body onto the air cleaner housing
(page 5-70).
5-84
wiClth
between the banCI enCls is
±
0.04 in).
INSULATORS
#1, #2 INSULATOR BAND
I
±
,
7 ± 1 mm (0.28 ± 0.04 in)
#3, #4 INSULATOR BAND