ANTI-LOCK BRAKE SYSTEM (ABS; CB600FA)
WHEEL SPEED SENSOR
AIR GAP INSPECTION
Support the motorcycle securely using a hoist or
equivalent and raise the wheel off the ground.
Measure the clearance (air gap) between the sensor
and pulser ring at several points by turning the
wheel slowly.
It must be within specification.
STANDARD: 0.2- 1.2 mm (0.01 - 0.05 in)
The sensor air gap cannot be adjusted.
If it is not within specification, check each installa
tion part for deformation, looseness and damage.
REPLACEMENT
Lift and support the fuel tank (page 3-5).
FRONT WHEEL SPEED SENSOR
Disconnect the front wheel speed sensor 2P (Blue)
connector.
Release the sensor wire from the clamp.
Remove the bolt and release the sensor wire from
the hose clamp.
16-24
r
ron •
t·
rF
I