Honda CB 600F Hornet 2007 Shop Manual page 379

Check the oil lock valve for wear or damage.
Replace the fork damper, if
aged.
Place the fork tube in V-block and measure the
run out.
Actual runout is 1/2 of the total indicator reading.
SERVICE LIMIT: 0.20 mm (0.008 in)
Fork tube. bushing/slider bushing/back-up ring
Visually inspect the slider and fork tube bushings.
Replace the bushings if there is excessive scoring or
scratching, or if the teflon Is worn so that the copper
surface appears on more than 3/4 of the entire sur­
face.
Check the back-up ring; replace it if there is any dis­
tortion at the points shown.
FRONT WHEEL/SUSPENSION/STEERING
any
components is dam­
OIL LOCK VALVE
BUSHING
BACK-UP RING
CHECK POINTS
COPPER SURFACES
13-25