Honda CB 600F Hornet 2007 Shop Manual page 401

REAR WHEEL
REMOVAL
Loosen the rear axle nut.
Support the motorcycle using a safety stand or a
hoist, raise the rear wheel off the ground.
Adjust the drive chain slack fully (page 3-19).
Remove the axle nut and washer.
Push the rear wheel forward.
Remove the rear axle.
Derail the drive chain from the driven sprocket.
C8600FA: Be Remove the rear wheel.
careful norro
NOTE:
damage rhe speed
• Do not operate the brake pedal after removing
sensor on the brake
the wheel. To do so will cause difficulty in fitting
caliper.
the brake disc between the brake pads.
Remove the side collars.
INSPECTION
Axle
Place the axle in V-blocks and measure the runout.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMIT: 0.2 mm (0.01 in)
REAR WHEEL/SUSPENSION
14-7