Honda CB 600F Hornet 2007 Shop Manual page 352

CYLINDER INSPECTION
Inspect the cylinder bore for wear or damage.
Measure the cylinder 1.0. in X and Y axis at three
levels.
Take the maximum reading to determine the cylin­
der wear.
SERVICE LIMIT: 67.10 mm (2.642 in)
Calculate the piston-to-cylinder clearance.
Take a maximum reading to determine the clear­
ance.
Refer to the procedures for measurement of the pis­
ton 0.0. (page 12-16).
SERVICE LIMIT: 0.10 mm (0.004 in)
Calculate the taper and out-of-round at three levels
in X and Y axis. Take the maximum reading to
determine them.
SERVICE LIMITS:
0.10 mm (0.004 in)
Taper:
Out-of-round: 0.10 mm (0.004 in)
The cylinder must be rebored and an oversize pis­
ton fitted if the service limits are exceeded.
The following oversize piston is available:
0 . . 25 mm (0.010 in)
The piston to cylinder clearance for the oversize pis­
ton must be: 0.015- 0.050 mm (0.0006 - 0.0020 in).
Inspect the top of the cylinder for warpage.
SERVICE LIMIT: 0.10 mm (0.004 in)
CRANKSHAFT /PISTON/CYLINDER
:-
0 •
_:
-
:•: � • - • .,_,.. 111�� •I
1.
TOP
MIDDLE
--
BOTTOM
•
. • I
l �
12-17