Honda CB 600F Hornet 2007 Shop Manual page 394

FRONT WHEEL/SUSPENSION/STEERING
Install the meter stay and tighten the bolts securely.
Route the clutch cable to the guide of meter stay.
Route the front brake hose to the guide of meter
CB600FA only:
stay.
Attach the immobilizer receiver, ignition switch
Roure rhehoses.
wires and cables wires clamp and main harness wire clamp to the
properly (page 1· meter stay.
Attach the engine stop switch wire clip to the meter
23).
stay.
Connect the immobilizer receiver 4P (Natural) and
ignition switch 2P (Blown) connectors.
Install the following:
- front wheel (page 13-19)
- combination meter (page 20·10)
- headlight unit (page 20-6)
STEERING HEAD BEARING PRE-LOAD
Support the motorcycle securely using safety
stands or a hoist and raise the front wheel off the
ground.
Position the steering stem straight ahead.
Hook a spring scale to the fork tube between the
fork top and bottom bridges.
Make sure there is no cable, wire harness or hoses
interference.
Pull the spring scale keeping it at a right angle to the
steering stem.
Read the scale at the point where the steering stem
just starts to move.
STEERING BEARING PRE-LOAD:
8.8-13.7 N (0.9-1.4 kgf, 2.0-3.1 lbf)
If the readings do not fall within the limits, readjust
the steering bearing adjustment.
13-40
BRAKE HOSE GUIDE
(CB600FA only)
CLUTCH
CABLE GUIDE