Honda CB 600F Hornet 2007 Shop Manual page 92

BRAKE LIGHT SWITCH
The front brake Adjust the brake light switch so that the brake light
ltght switch does comes on just prior to the brake actually being
not require engaged.
adjustment.
If the light fails to come on, adjust the switch so that
the light comes on at the proper time.
Hold the switch body and turn the adjuster. Do not
turn the switch body.
HEADLIGHT AIM
Place the motorcycle on a level surface.
Adjust the headlight aim vertically by turning the
Adjust lhe headlight
a,m as specified by vertical beam adjusting screw.
local laws and A clockwise rotation moves the beam up and coun-
terclockwise rotation moves the beam down.
regulations.
Adjust the headlight aim horizontally by turning the
horizontal beam adjusting screw.
A clockwise rotation moves the beam toward the
right and counterclockwise rotation moves the
beam toward the left.
CLUTCH SYSTEM
Measure the clutch lever freeplay at the end of the
clutch lever.
FREEPLAY:
Minor adjustment is made using the upper adjuster
at the clutch lever.
Loosen the lock nut and turn the adjuster.
I
NOTICE
The adjuster may be damaged if it is positioned too
far out, leaving minimal thread engagement.
If the adjuster is threaded out near its limit and the
correct freeplay cannot be obtained,
adjuster all the way in and back out one turn.
Tighten the lock nut while holding the adjuster and
make a major adjustment as described as follow.
10- 20 mm (3/8 - 13/16 in)
I
C.
BRAKE LIGHT SWITCH
VERTICAL BEAM ADJUSTING SCREW
�
HORIZONTAL BEAM ADJUSTING SCREW
10-20 mm (3/8-13/16 in)
!
turn the
MAINTENANCE
"'
dllJ.--"
3-27