Honda CB 600F Hornet 2007 Shop Manual page 105

LUBRICATION SYSTEM
Remove the oil pump cover and dowel pins.
Remove the thrust washer, drive pin, oil pump
shaft. outer rotor and inner rotor from the oil pump
body.
Clean all disassembly parts thoroughly.
INSPECTION
Temporarily install the outer and inner rotors into
If any portion of the
the oil pump body.
oil pump,,, worn
Temporarily install the drive pin and oil pump shaft.
beyond the seNice
limit. replace the
011
Measure the rotor tip clearance.
pump as an
SERVICE LIMIT: 0.20 mm (0.008 in)
assembly.
Measure the pump body clearance.
SERVICE LIMIT: 0.35 mm (0.014 in)
4-10
OIL PUMP COVER
DOWEL PINS
OUTER ROTOR
DRIVE PIN
INNER ROTOR
TWASHEA
OIL PUMP
HAFT