Honda CB 600F Hornet 2007 Shop Manual page 417

Make sure the needle rollers in the bearing are in
position.
Apply grease to new dust seal lips.
Install the dust seals with the flat surface facing out
until they are flush with the pivot outer surface.
Install the pivot collar.
Install the drive chain slider, aligning the slit with
the lug on the swingarm.
Install the drive chain slider bosses into the holes in
the swingarm.
Install new drive chain slider bolts with washers and
tighten them to the specified torque.
TORQUE: 9.0 N-m (0.9 kgf•m, 6.6 lbf•ft)
INSTALLATION
Apply thin coat of grease to the swingarm pivot bolt
surface.
Install the swingarm into the frame.
Install the swingarm pivot bolt from the left side.
REAR WHEEL/SUSPENSION
DUST SEALS
BOSSES/HOLES
,
DRIVE CHAIN SLIDER
•
-,
�
DRIVE CHAIN SLIDER
Align
14-23