Figure 5-38 Location Of The Mounting Screws - Sun Microsystems Sun Fire V60x Manual

FIGURE 5-38
17. Slide the board toward the front of the chassis until the I/O connectors are clear of
the chassis I/O openings, lift the server board from the chassis, and place it on an
antistatic pad.
18. Remove the power distribution board from the white 24-pin power connector.
Place the server board in an antistatic bag.
19. Remove the replacement server board from its packaging and antistatic bag.
20. Connect the power distribution board to the 24-pin power connector on the new
server board.
21. Ensure that the Mylar insulator sheet is seated securely over the standoffs, is
laying flat on the chassis floor, and that the edge of the sheet is seated below the
studs in the rear chassis wall.
22. Insert the back edge of the board under the three retention pins located at the rear
of the chassis.
23. While placing the board on the chassis standoffs, carefully align the board I/O
connectors with the rear chassis I/O openings.
24. Adjust the board's position so that the three mounting holes rest securely on the
shouldered standoffs.
5-56 Sun Fire V60x and Sun Fire V65x Servers—Troubleshooting Guide • November 2003
Location of the Mounting Screws