3. Unplug the serial and SCSI cables from the rear I/O board.
4. Using a Phillips No.1 screwdriver, remove the screws and washers from the base
memory board (see
FIGURE A-3
5. Position the new spacers over the screw holes (see
6. Insert the new, longer screws with their washers through the holes in the new
board (see
Place the spring washer on the screws first, and then the plain washer.
7. Position the second memory board above the base memory board so that the
connectors line up and the screws pass through the spacers (see
8. Engage the screws in their threads to ensure the board is in the correct position.
104
Netra t1 User and Administration Guide • June 2000
and
FIGURE A-3
Removing the Mounting Screws from the Currently Installed Memory Board
).
FIGURE A-4
).
FIGURE A-4
FIGURE A-4
Remove short screws
Memory Board
).
).
FIGURE A-4