Figure 7-2 Drive Bay Cover Locations - Sun Microsystems Netra CT 810 Service Manual

H D
D 0
AB O
RT
H D
D 0
RE
SE T
AL AR
M /U
SE R
RE
AD
Y
AB O
RT
ET HE
RN
ET RE
SE T
AL AR
M /U
SE R
RE AD
Y
micr osys
tem s
ET HE
RN
ET
CO
M
HO
T
SW
AP
HO
TS W
AP
micr
osys
tem s
CO
M
HO
T
SW
AP H D
HO
TS W
AP
Drive Bay Cover Locations
FIGURE 7-2
9. Loosen the captive screws that hold the drive bay cover in place.
For the Netra CT 810 server, use a No. 1 Phillips screwdriver to loosen the four
■
captive screws (two on top and two on the bottom).
For the Netra CT 410 server, use a No. 2 Phillips screwdriver to loosen the one
■
captive screw on top.
10. Remove the drive bay cover.
11. Locate the hard drive that you want to replace.
In a Netra CT 810 server, HDD0 is the upper hard drive and HDD1 is the lower hard
drive.
12. Unlatch the disk drive handle to release it.
Push down in the direction of the arrow to release the bracket handle latch.
13. Pull the bracket handle out and swing it open.
Chapter 7 Removing and Replacing Hard Drives and Removeable Media
Drive bay cover, Netra CT 410 server
Drive bay cover, Netra CT 810 server
AB O
RT
RE
SE T
AL AR
M /U
SE R
RE
AD
Y
ET HE
RN
ET
D 1
micr
osys
tem s
CO
M
HO
TS W
AP
HO
T
SW
AP
7-7