Installing The Hard Drive; Figure 2-2 Sliding The Drive Out Of The Drive Bay - Sun Microsystems Netra 210 Service Manual

FIGURE 2-2
7. Set the drive aside on an antistatic mat.
8. Determine your next steps:
If you were directed here by another procedure, return to that procedure.
If you are replacing the hard drive with another, go to
the Hard Drive" on page
If you are not replacing the hard drive, go to
page
2.2.2

Installing the Hard Drive

1. Open the bezel.
See Section 1.5, "Opening the Bezel" on page
2. Locate where the hard drive is to be installed.
The hard drives are located at the front of the chassis, on the right side. The top
drive is HDD1; the bottom drive is HDD0.
3. Remove the replacement hard drive from its shipping container and antistatic
packaging.
4. Press the drive button to release the drive latch.
The latch opens.
5. Orient the hard drive with the drive latch towards you and the label facing up.
6. Gently slide the drive into the drive bay by pressing on the area between the
drive button and the drive status LEDs.
See
FIGURE 2-3
2-4 Netra 210 Server Service Manual • March 2006
Sliding the Drive Out of the Drive Bay
2-4.
5-3.
.
Section 2.2.2, "Installing
Section 5.2, "Closing the Bezel" on
1-5.