Figure B-7 System Cabinet Front, Bolt Access Plate And Screws - Sun Microsystems StorEdge A7000 Service Manual

5. For easier access to the bolts you tighten later, remove the rear doors of each
cabinet. For each cabinet:
a. Open the rear door.
b. Remove the pins at each hinge.
c. Lift the door up and off.
6. Open the system cabinet front door.
7. At the bottom right of the cabinet blower, remove the two Philips screws securing
the bolt access panel. Set the plate and screws aside. See
Bolt access plate
and screws (2x)
Blower fans
System Cabinet Front, Bolt Access Plate and Screws
FIGURE B-7
After removing access plate,
install hex-head bolt and
washer inside cabinet here
Appendix B Installing the HDSA Expansion Cabinet
.
FIGURE B-7
B-15