Setting The System Time And Date - Nortel 1000E Installation And Configuration Manual

Page 250 of 488

Setting the system time and date

553-3041-210 Standard 4.00
Installing software on an MG 1000T Small System Controller
*** WARNING *** A system restart will be invoked
as part of the software installation process
Are you sure you wish to perform the installation?
(y/n/[a]bort): _
13 Perform the installation.
a. Enter: y
System response (if software installation successful):
Installation completed successfully.
b. The system then reboots.
Rebooting...
Once the installation program completes, messages appear on the
terminal screen. When the message "INIXXX" appears, the system is
operational.
Follow Procedure 61 to set the system time and date. You can also use
Element Manager or OTM.
Procedure 61
Setting system time and date
1 Log in to the CS 1000E.
a. Enter the command:
LOGI
System response:
PASS?
b. Enter the default password:
0000
2 Access LD 2. Enter the command:
LD 2
September 2007
End of Procedure