Configuring voice gateway channels using LD 14
Installing and configuring a Voice Gateway Media Card
The VGW channels for this card are displayed. See Figure 104 on
page
327.
Note: If you receive an error that a pad category table does not exist for
this customer, go back to your DTI configuration step, (see "Basic system
telephony configuration" on
Block (DDB), and then perform this procedure again.
Figure 104
VGW channels list
The voice gateway channels are also called "DSP channels" or the card's
"physical TNs." Follow Procedure 78 on
gateway channels using LD 14.
Communication Server 1000E
page
479) and create a default DTI Data
End of Procedure
page 328
Installation and Configuration
Page 327 of 488
to configure the voice