Telnet Terminal Server Virtual Management Port - Nortel 1000E Installation And Configuration Manual

Page 258 of 488

Telnet Terminal Server virtual management port

553-3041-210 Standard 4.00
Connecting a Terminal Server
define server ip primary gateway address [ip address]
4 Check Terminal Server configuration. Enter:
list server ip
Example commands:
define server ip address 172.16.3.50
define server ip subnet mask 255.255.255.0
define server ip primary gateway address 172.16.3.1
Connect the Terminal Server ethernet port to the ELAN using a CAT5
ethernet cable. The virtual management port 0 is accessible from an online PC
using a telnet session. The Terminal Server can now be configured from the
on-line PC.
Procedure 64
Run telnet from PC
1 Use Start > Run
Input telnet command: telnet ip-address port#
Where:
ip-address: Terminal Server IP address
Port#: The target port number on Terminal Server=2000+(xx x 100)
For Terminal Server virtual management port xx=0
Example: telnet 172.16.3.50 2000
2 Press <CR> until the MRV login prompt appears.
3 Input login password and username to log in to the virtual management
port. The default password is "access".
September 2007
End of Procedure
End of Procedure