Nortel 1000E Installation And Configuration Manual page 185

Figure 62
Leader/Follower Signaling Server configuration
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Note: This step will over-write all existing configuration parameters
on this Signaling Server.
Please select the role of this Signaling Server.
If this Signaling Server will be a Leader then its data networking
and IP Telephony parameters must be entered now. (This will pre-
configure the IP Telephony node files.)
If this Signaling Server will be a Follower then its data networking
and IP Telephony parameters must be configured through Element
Manager later.
Please enter:
<CR> -> <a> - Set this Signaling Server as a Leader.
<b> - Set this Signaling Server as a Follower.
<q> - Quit.
Enter Choice>
Installing and configuring the Signaling Server software
9 Configure the Signaling Server as Leader or Follower. See Figure 62.
• If there is not already a Leader Signaling Server in the IP Telephony
node, or if the Signaling Server is to be a stand-alone Signaling
Server, enter a at the prompt to configure this Signaling Server as
Leader.
• If there is already a Leader Signaling Server in the IP Telephony
node, enter b at the prompt to set this Signaling Server as Follower.
Then go to step 13 on
For more information about Leader and Follower Signaling Servers, see
IP Line: Description, Installation, and Operation (553-3001-365).
Communication Server 1000E
page 189.
Installation and Configuration
Page 185 of 488