Installing And Cross-Connecting - Nortel 1000E Installation And Configuration Manual
Nortel 1000e server: install guide
Hide thumbs
Also See for 1000E:
- Upgrade (230 pages) ,
- Maintenance manual (222 pages) ,
- Regulatory and safety information (2 pages)
Table of Contents
Advertisement
Installing and cross-connecting
an external alarm from a PFTU
Contents
Introduction
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing an alarm using an alarm port assigned in LD 15. . . . . . . . . .
Installing an alarm through QUA6 PFTU connections. . . . . . . . . . . . .
This chapter describes the procedures for connecting an external alarm to the
CS 1000E system.
This chapter contains the following procedure: Procedure 118: "Installing an
alarm using an alarm port assigned in LD 15" on
The following are the two methods of connecting an external alarm to the
CS 1000E system:
•
through an alarm port assigned in software
•
through contacts in a QUA6 Power Failure Transfer Unit (PFTU)
Communication Server 1000E
Page 455 of 488
page 456
Installation and Configuration
455
456
457
Advertisement
Chapters
Table of Contents
