Checking Pty Status - Nortel 1000E Installation And Configuration Manual

Checking PTY status

Configuring the CS 1000E Call Server
10 Enter the command:
TTYLOG NO
11 Enter the command:
BANR YES
System response:
MEM AVAIL: (U/P):1019130 USED U P: 138064 22453
TOT: 3555327
DISK RECS AVAIL: 491
TMDI D-CHANNELS AVAIL: 0 USED: 0 TOT: 0
DCH AVAIL: 80 USED: 0 TOT: 80
AML AVAIL: 15 USED: 1 TOT: 16
ADAN DATA SAVED
12 Enter the command:
ADAN ****
Follow Procedure 51 to check the PTY status.
Procedure 51

Checking PTY status

Pseudo-terminals show enabled only if you are using them.
1 Enter the command:
LD 37
2 Enter the command:
STAT
System response:
TTY 0: ENBL DES: ...
TTY 1: ENBL DES: ...
TTY 2: ENBL DES: ...
TTY 3: ENBL DES: ...
TTY 12: DSBL DES: ether 1
Communication Server 1000E
End of Procedure
Installation and Configuration
Page 209 of 488