Saving Configuration Changes - Nortel 1000E Installation And Configuration Manual

Table 39
LD 14 – Configure physical TNs (Part 2 of 2)
Prompt Response
MAXU 32
24
IPTN YES
ZONE 0-255
CUST xx

Saving configuration changes

Installing and configuring a Voice Gateway Media Card
Description
32 is the maximum number of voice Media Gateway channels on
the Media Card.
For MG 1000T when XTRK = ITG2
24 is the maximum number of voice Media Gateway channels on
the ITG-P Line card.
ITG Physical TN.
MG 1000T Zone number to which the Voice Gateway Media Card
Physical TNs belong.
Verify that the zone exists in LD 117.
The ZONE prompt is not available when configuring VGW in an
MG 1000E. The VGWs are assigned the same zone as the
MG 1000E.
Note: If the Zone of an MG 1000E is changed, all VGW in the
MG 1000E must be removed and reconfigured to assume the
new Zone of the MG 1000E.
The customer to which the IPTN resources are assigned.
Note: This means that for multi-customer CS 1000E systems,
each customer must have a dedicated IP Telephony node for
IP Phones.
4 Exit from LD 14. Enter the command:
****
Perform a datadump to save configuration changes. Complete the steps in
Procedure 97: "Performing a datadump using Element Manager" on
page 380.
Communication Server 1000E
End of Procedure
Installation and Configuration
Page 329 of 488