Configuring The Ip Phone Boot Parameters - Nortel 1000E Installation And Configuration Manual

Configuring the IP Phone boot parameters

The IP Phone boot parameters are configured during telephone installation.
The following configuration modes are available:
• Manual configuration
— All of the IP Phone's boot parameters are statically configured at the
IP Phone.
— See Procedure 107: "Entering IP Telephone boot parameters using
manual configuration" on
• Partial Dynamic Host Configuration Protocol (DHCP) mode
— Works with standard DHCP server. The DHCP server automatically
provides the IP Phone with an IP address; the remainder of the IP
Phone's boot parameters are statically configured at the IP Phone.
— See Procedure 108: "Entering IP Phone boot parameters using full
DHCP parameters" on
• Full DHCP mode
— Requires special configuration of the DHCP server to recognize the
IP Phone. The DHCP server provides all boot parameters to the IP
Phone, including IP address and server address.
— See Procedure 109: "Entering IP Phone boot parameters using
partial DHCP parameters" on
For configuration of the DHCP server, see Converging the Data Network with
VoIP (553-3001-160).
Communication Server 1000E
Installing and configuring IP Phones
page
page 428.
page
Page 424 of 488
425.
430.
Installation and Configuration