Keycodes - Nortel 1000E Installation And Configuration Manual

Page 244 of 488

Keycodes

Keycode rejection
553-3041-210 Standard 4.00
Installing software on an MG 1000T Small System Controller
A security keycode system protects the installation of software, feature set,
and license parameters. The keycodes required for a new installation or
system upgrade are on the Keycode Data Sheet that is supplied with the
software and security device.
A different keycode is assigned to each site for a particular combination of
items such as software release, feature set, and LICENSES. The installation
does not continue unless correct keycodes are entered.
Note: If an invalid keycode is entered, the software and databases on the
present system are not affected.
Note: Contact your support group if the Keycode Data Sheet is missing.
The Software Installation Program validates the keycodes. If the keycodes are
valid then the installation continues. If the system rejects the keycodes, then
ensure that the:
• correct keycodes have been entered
• software is the correct version for the site
• feature set data has been entered correctly
• License parameter data has been entered correctly
If the correct data has been entered and the keycodes are rejected, then stop
the installation and call the support group.
The system limits the validation of keycodes to three consecutive
attempts. If the third consecutive attempt is unsuccessful, then the
Software Installation Program returns to the main menu. Any data
entered during this session is lost.
September 2007
IMPORTANT!