Nortel 1000E Installation And Configuration Manual page 253

Connecting a Terminal Server
Contents
Introduction
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Configuring a Terminal Server . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Telnet Terminal Server virtual management port . . . . . . . . . . . . . . . . .
Telnet CS 1000E COM port from a PC . . . . . . . . . . . . . . . . . . . . . . . .
Configuring a transparent rlogin port . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessing an MRV Console Port through the on-board modem . . . . .
CS 1000E COM port types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Many third-party applications require serial port interfaces to provide a
connection to a PBX. As well, support staff traditionally use serial ports to
connect maintenance terminals and modems to a system for maintenance. As
the CS 1000E Call Server provides only two local serial ports for these
purposes, an IP-based Terminal Server is required to provide the necessary
standard serial ports for applications.
As the Terminal Server is configured to automatically log in to the active Call
Server upon start-up, only one Terminal Server is required for the system. It
can be located anywhere on the LAN. One connection from each Call Server
COM1 port is connected to the Terminal Server.
Communication Server 1000E
Page 253 of 488
Installation and Configuration
253
255
258
259
260
264
265