Configuring a Small System Controller
4
Install the 100BaseT daughterboard (dual port) in slot 2 of the SSC:
a.
Locate the alignment pin on the SSC.
b.
Insert the alignment pin into the appropriate hole on the
daughterboard.
c.
Secure the 100BaseT daughterboard (dual port) using metal
screw-downs on the SSC.
d.
Route the NTDU0606 Ethernet cable(s) through the plastic guides on
the SSC.
Figure 82 on
Daughterboards (dual port).
5
Install the SSC in a Media Gateway.
6
Connect each labeled Ethernet cable to the corresponding port number
bulkhead connectors.
CAUTION — Service Interruption
7
Reinstall the front cover.
Communication Server 1000E
page 230
shows an SSC with two 100BaseT
End of Procedure
Page 229 of 488
Installation and Configuration