Configuring Login Ids And Passwords - Nortel 1000E Installation And Configuration Manual

Page 202 of 488

Configuring login IDs and passwords

553-3041-210 Standard 4.00
Configuring the CS 1000E Call Server
4 Enter the command:
TYPE PWD
5 Enter the command:
PWD2 <xxxx>
Where:
<xxxx> = your current level 2 password
6 Enter the command:
LNAME_OPTION YES
System response:
DEFAULT LOGIN NAMES SAVED
MEM AVAIL: (U/P): 1015893 USED U P: 138773 24981
TOT: 1179647
DISK RECS AVAIL: 486
TMDI D-CHANNELS AVAIL: 0 USED: 0 TOT: 0
DCH AVAIL: 80 USED: 0 TOT: 80
AML AVAIL: 15 USED: 1 TOT: 16
7 Enter the command:
REQ ****
For increased security:
• Change the default login username and password.
The default login is username admin1 and password 0000, as used
throughout this guide.
• Configure the Limited Access Password (LAPW) IDs and passwords.
September 2007
End of Procedure