Nortel 1000E Installation And Configuration Manual page 251

Installing software on an MG 1000T Small System Controller
3 Set the time and date. Enter the command:
STAD <day> <month> <year> <hour> <minute> <second>
Where:
<day> = the day of the month (1-31).
<month> = the month number (1-12).
<year> = the year, in four-digit or two-digit form (see Note on
page 251).
<hour> = the hour of the day (0-23).
<minute> = the minutes (0-59).
<second> = the seconds (0-59).
Sample entry:
STAD 2 9 2002 16 47 0
4 Print the current time and date. Enter the command:
TTAD
Sample system response:
MON 02 09 2002 14 47 05
Note: Except for the year, the other entries in the time-of-day output are
two-digit numbers. The year can be any year from 1901 to 2099 inclusive.
It can be input as a full four-digit field or as a two-digit short form. The
two-digit short form is assumed to be in the range 1976 to 2075 and the
appropriate addition is made when calculating the day of week and leap
years.
5 Exit from LD 2. Enter the command:
****
Communication Server 1000E
End of Procedure
Installation and Configuration
Page 251 of 488