Connecting A Media Gateway To A Media Gateway Expansion; Connecting A Media Gateway To A Media Gateway; Expansion - Nortel 1000E Installation And Configuration Manual
Nortel 1000e server: install guide
Hide thumbs
Also See for 1000E:
- Upgrade (230 pages) ,
- Maintenance manual (222 pages) ,
- Regulatory and safety information (2 pages)
Table of Contents
Advertisement
Page 116 of 488
Connecting a Media Gateway to a Media Gateway
Expansion
553-3041-210
Standard 4.00
Connecting CS 1000E system components
Procedure 21 describes how to connect a Media Gateway Expander to the
Media Gateway. The Media Gateway Expander Cable Kit (NTDK89)
contains two NTDK95 cables used to connect the Media Gateway Expander
to the Media Gateway. One cable provides DS-30X connectivity while the
second cable provides CE-MUX connectivity to slot 10 only.
Procedure 21
Connecting a Media Gateway to a Media Gateway Expansion
1
Connect one NTDK95 cable from the CE-MUX connector at the back of
the Media Gateway to the CE-MUX connector at the back of the Media
Gateway Expander.
2
Tighten the screws on the connectors.
3
Connect the other NTDK95 cable from the DS-30X connector at the back
of the Media Gateway to the DS-30X connector at the back of the Media
Gateway Expander.
4
Tighten the screws on the connectors. Figure 36 on
Media Gateway and Media Gateway Expander connected with the two
NTDK95 cables.
September 2007
page 117
shows the
Advertisement
Chapters
Table of Contents
