Connecting a Signaling Server to the TLAN subnet
Inserting a Shielded 50-pin to Serial/ELAN/TLAN
adapter onto a Media Card
Connecting MG 1000T system components
Follow Procedure 37 to connect a Signaling Server to the TLAN subnet.
Procedure 37
Connecting a Signaling Server to the TLAN subnet
1
Connect a standard CAT5 cable to the TLAN network interface connector
(top) RJ-45 jack on the back of the Signaling Server, see Figure 43 on
page
162.
2
Connect the other end of the standard CAT5 cable to an RJ-45 TLAN
network interface on the data network switch (BayStack 470-24T).
The Shielded 50-pin to Serial/ELAN/TLAN adapter, shown in Figure 44 on
page
164, provides access to the TLAN and ELAN Ethernet Ports. The
adapter breaks out the signals from the I/O connector to the following:
•
ELAN (management) network interface
•
TLAN (telephony) network interface
•
one RS-232 (local console) port
Communication Server 1000E
End of Procedure
Installation and Configuration
Page 163 of 488