user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
Click the appropriate orange bar to expose the available ports or LAGs. The Port Selection
3.
Table specifies list of all available valid interfaces for ACL mapping. All non-routing physical
interfaces and interfaces participating in LAGs are listed.
To add the selected ACL to a port or LAG, click the box directly below the port or LAG
•
number so that an X appears in the box.
To remove the selected ACL from a port or LAG, click the box directly below the port
•
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.
Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
4.
the latest value of the switch.
Click APPLY to save any changes to the running configuration.
5.
Field
Interface
Direction
ACL Type
ACL ID/Name
Sequence Number
IP Binding Table
Use the IP Binding Table page to view or delete the IP ACL bindings.
To display the IP Binding Table, click Security
The following table describes the information displayed in the IP ACL Binding Table.
To delete an IP ACL-to-interface binding, select the check box next to the interface and click
DELETE.
Web Management User Guide
Description
Displays selected interface.
Displays selected packet filtering direction for ACL.
Displays the type of ACL assigned to selected
interface and direction.
Displays the ACL Number (in the case of IP ACL) or
ACL Name (in the case of named IP ACL and IPv6
ACL) identifying the ACL assigned to selected
interface and direction.
Displays the Sequence Number signifying the order
of specified ACL relative to other ACLs assigned to
selected interface and direction.
ACL> Advanced
304
Binding Table.