Sntp Unicast Client Poll-Retry; Sntp Multicast Client Poll-Interval - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

4.3.6 sntp unicast client poll-retry

This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
Default
Format
Mode
4.3.6.1 no sntp unicast client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default value.
Format
Mode

4.3.7 sntp multicast client poll-interval

This command will set the poll interval for SNTP multicast clients in seconds as a power
of two where
Default
Format
Mode
4.3.7.1 no sntp multicast client poll-interval
This command resets the poll interval for SNTP multicast clients to its default value.
Format
Mode
Port and System Setup Commands
1
sntp unicast client poll-retry <poll-retry>
Global Config
no sntp unicast client poll-retry
Global Config
can be a value from 6 to 16.
<poll-interval>
6
sntp multicast client poll-interval <poll-inter-
val>
Global Config
no sntp multicast client poll-interval
Global Config
v1.0, March 2006
4-11