Table of Contents
Advertisement
PathFinder 350S User Manual
If communications are not restored then remove all racks and tubes from the Sorter
and reset the system. See Section 7.6 for the reset procedure.
8.4.2
User Interface Cannot Connect to Local Lost
This error message may be displayed when first starting the user interface under
some circumstances. The error message displayed is shown in Figure 8-7.
To recover from this error simply press Try Again. The user interface will refresh
itself within 30 seconds.
Page 98
Figure 8-7 User Interface Cannot Connect Message
© Copyright 2010 Aim Lab Pty Ltd
03P27-42 Rev A
Advertisement
Table of Contents
Need help?
Do you have a question about the PathFinder 350S and is the answer not in the manual?