6.7.10 Locations - Aim Lab PathFinder 350S User Manual

6.7.10 Locations

The locations table defines a list of location IDs that can be referred to by the LIS.
These location IDs are used in the profile gates configuration to relate the LIS
location ID to a tray gate.
03P27-42 Rev A
Heading
Profile ID This is the profile name that will be used to define the
workflow through the PathFinder 350S.
Tray Name This is the specimen tray to be configured.
Gate Index This is the gate in the specimen tray being configured.
Direction This defines whether the gate is used as an input or output.
Location ID This is the location ID the LIS will use to refer to the gate.
Figure 6-23 Example Locations Table
Heading
Location ID This is the name used by the LIS to refer to a Location. It is
case sensitive.
Description A meaningful description of the location ID.
Location Type This field categorises the Location for easier filtering.
Primary These define whether the tubes expected are primary or
secondary tubes, and whether they are capped or uncapped.
Secondary This is not used with the PathFinder 350S unless it is part of a
larger workcell that includes aliquoting, eg the PathFinder 900.
Specimen Type The specimen type (if any) to assign to any tube placed in this
location. This only applies to input locations. This setting is
overridden if the rack placed has a specimen type defined in
the Racks Registry.
© Copyright 2010 Aim Lab Pty Ltd
PathFinder 350S User Manual
Description
Description
Page 57