Post Installation; Figure 4-11 Home Page - Administrator Login - Aim Lab PathFinder 350S User Manual

PathFinder 350S User Manual
3)
4)
If the PathFinder 350S did not start up successfully, refer to the troubleshooting
section in Section 8.
4.5

Post Installation

These post installation checks should be performed before configuring the LIS
interface in order to validate the PathFinder 350S hardware.
Performing these checks involves navigating the user interface. If the user is
unfamiliar with the user interface, refer to Section 6 before attempting these
procedures.
These procedures require the user to login under administrator privileges. The
default username and password are shown below. The administrator password can
be changed via the User Accounts configuration, see Section 6.7.11:


Navigation Buttons
Tray Status
Page 34
The monitor may need to be turned on by pressing the monitor Power Button
shown to the left.
After Windows starts the workcell controller will start and the user interface
should display automatically. This may take a few minutes. The user
interface will start at the login screen.
Username: admin
Password: a
Status Panel

Figure 4-11 Home Page - Administrator Login

© Copyright 2010 Aim Lab Pty Ltd
Control
Buttons
Handover
Calibration
Current Profile
03P27-42 Rev A