Oil Pan And Oil Pump Strainer Components; Oil Pan And Oil Pump Strainer Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

1E-2 Engine Lubrication System:

Oil Pan and Oil Pump Strainer Components

[A]: Sealant application amount
"a": 3 mm (0.12 in.)
"b": 2 mm (0.08 in.)
1. Oil pan
: Apply sealant 99000-31250 to mating surface.
2. Strainer
Oil Pan and Oil Pump Strainer Removal and
Installation
Removal
1) Remove oil level gauge.
2) Remove exhaust No.1 pipe and exhaust manifold
stiffener referring to "Exhaust Pipe Removal and
Installation in Section 1K in related manual".
3) Drain engine oil by removing drain plug.
4) Remove transaxle lower stiffener referring to
"Manual Transaxle Unit Dismounting and
Remounting in Section 5B in related manual" or
"Automatic Transaxle Unit Dismounting and
Remounting in Section 5A".
5) Remove oil pan bolts and nuts.
6) Cut sealant at hatched part shown in figure using
special tool and hammer (1).
Special tool
(A): 09921–96510
NOTE
Be careful not to damage stud bolt (3)
between oil pan and cylinder block when
cutting sealant.
Repair Instructions
3. O-ring 8. Oil pan nut
4. Gasket 9. Oil pan bolt
5. Drain plug
6. Strainer bolt
7. Bracket bolt
7) Remove oil pan (2) from cylinder block.
S3RH0B1506002
: Tighten 11 N⋅m (1.1 kgf-m, 8.0 lb-ft) by the specified procedure.
: Tighten 11 N⋅m (1.1 kgf-m, 8.0 lb-ft) by the specified procedure.
: Tightening torque
: Do not reuse.
S3RH0B1506001
I3RH0B150002-01
I3RH0A150002-01