Handler I/O Board Replacement; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Ena rf network analyzers

Hide thumbs Also See for E5071C:

Table of Contents

Replacement Procedure

Handler I/O Board Replacement

TORX screwdriver, T10, T15, and T20

Refer to Figure 6-13 for this procedure.

Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.

Step 2. Disconnect the flat cable (item 1) from the handler I/O board.

Step 3. Remove the two TORX T10 screws (item 2) fastening the handler I/O board.

Step 4. Slide the handler I/O board toward backward (item 3).