Power Supply Assembly Replacement; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Replacement Procedure

Power Supply Assembly Replacement

Power Supply Assembly Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20
• Torque screwdriver, TORX T10 (set to 0.79 N-m / 7 lb-in)

Removal Procedure

Refer to Figure 6-11 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.
Step 2. Remove the two TORX T10 screws (item 1) fasting the angle (item 2) and lift it.
Step 3. Disconnect the power supply cables (item 3).
Step 4. Disconnect the cable form analog motherboard(item 4).
Step 5. Remove the two TORX T10 screws (item 5) from the rear panel.
Step 6. Remove the two TORX T10 screws and washers (item 6) fastening the power supply
holder.
Step 7. Lift the power supply assembly toward front side.
Step 8. Remove the three TORX T10 screws (item 7) fasting the angle.
282 Chapter 6