Pci Dsp Card And Gpib Card Replacement; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Replacement Procedure

PCI DSP Card and GPIB Card Replacement

PCI DSP Card and GPIB Card Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20
• Open-end torque wrench, 5/8 inch (set to 1.97 N-m / 17.4 lb-in)

Removal Procedure

Refer to Figure 6-15 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.
Step 2. Remove the three TORX T10 screw (item 1) fastening the angle and lift it.
Step 3. Remove the two TORX T10 screw (item 2) fastening the stay and lift it.
Step 4. Disconnect the flat cables (item 3).
Step 5. Disconnect the flat cable (item 4) from the handler I/O board.
Step 6. Remove the four TORX T10 screw (item 5) fastening the card to the rear panel.
Step 7. Disconnect the USB(USBTMC) interface card (item 6) from the Digital Motherboard and
lift it.
Step 8. Disconnect the assembly (item 7) from the Digital Motherboard and lift it.
Step 9. Remove the PCI DSP Card or GPIB Card.
For removing the PCI DSP Card.
• Remove the two 5/8 inch nuts (item 8) fastening the angle.
• Remove a TORX T10 screw (item 9) fastening the angle.
For removing the GPIB Card.
• Remove the two TORX T10 screws (item 10) fastening the angle.
290 Chapter 6