Usb (Usbtmc) Interface Card Replacement; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Ena rf network analyzers

Hide thumbs Also See for E5071C:

Table of Contents

Replacement Procedure

USB (USBTMC) Interface Card Replacement

TORX screwdriver, T10, T15, and T20

Refer to Figure 6-14 for this procedure.

Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.

Step 2. Remove the three TORX T10 screw (item 1) fastening the angle and lift it.

Step 3. Disconnect the flat cable (item 2) from the PCI DSP card.

Step 4. Remove the two TORX T10 screws (item 3) fastening the card to the rear panel.

Step 5. Disconnect the assembly (item 4) from the Digital Motherboard and lift it.

Step 6. Remove the two TORX T10 screws (item 5) fastening the angle.